TITLE : DEVELOPMENT OF PCB LAYOUT

METHODOLOGY (5)

CONTENT:

 

 

Development of PCB layout is a process after I have completely done to design my schematic diagram. Schematic diagram have to be convert into PCB layout design before can be proceed to another process which is to make it easy to print out on the covered of stick paper, and then the PCB layout printed need to be iron on PCB board to make the design were stick on the PCB board. The last step is etching by using FERRIC III CLORIDA ACID, to make the connection in the circuit so that the voltage will flow in the circuit after all component has been attached.

OBJECTIVE:
1.) To learn how to complete the PCB layout connection.
2.) To learn how to do the etching process.
3.) To know that the connection should be correct and not disconnected between all the component.

CONCLUSION:
I have successfully completing the PCB layout design without any problems.