Title : Schematic Diagram of Project

METHODOLOGY (3)

CONTENT:

This is schematic diagram of my project, referring of the block diagram, I have done this schematic diagram completely. It was done almost 2 weeks with others helped. To design this schematic,I have used Protel software. After completing this schematic diagram, so I can continue with others part such as converting schematic diagram into PCB layout to make it easy to print on the covered of sticky paper, and then the PCB layout printed need to be iron on PCB board. The last step is etching by using FERRIC III CLORIDA ACID. After etching also have another stage but I will explain it at others post.

OBJECTIVE:

1.) To identified what component to be use by referring of the block diagram and then design it on Protel software to run it.
2.) To make sure all component can be interface for each other and function.
3.) To trace any error occurs.